7.3 - Parameter Checking One key feature is to see if the camera parameters are set up correctly. For example, scroll down the list to the Transport Layer and open up GigE Vision Scroll again to the bottom of that and you can see that the IP Address is set, and that Packet Size (SCPS), and InterPacketDelay (SCPD) have been set according to the registry. 7.4 - Image Acquisition Checking The major debug feature is to be able to see if the control tool can take pictures. Once it can, then it is assured that AutoVISION/Visionscape can. To take a picture, click on the “Start Acquisition” button on the menu bar. A window will open up to show the image.
Image time stats will show up in the bottom bar. Observe the image. Any ripping in the image is an indication of dropped packets and that packet parameters may have to be adjusted. If the Jumbo Packet setting is correct, then increase to the Interpacket delay. Do this iteratively until the image is solid. Using Sentech STC-M Cameras with AutoVISION and Visionscape Page 29 of 35