If the Tool-Ready indicator on the jump start clamp cable becomes solid green, it means you can start the vehicle. If the Tool-Ready indicator does not become solid green, it means the voltage between the jump start clamps is lower than 3V. The vehicle will not get started successfully in this mode. You can try the BOOST mode. 2. Start the vehicle within 30 seconds. 3. Disconnect the jump start clamp cable from the vehicle battery when the vehicle gets started. NOTE: If the vehicle fails to get started, please disconnect the jump start clamps from the vehicle battery. You can try again 20 seconds later.
We strongly recommend that you do not jump start a vehicle for more than three times within two minutes. 4.3.2 BOOST Mode If a vehicle fails to get started in the Jump Start mode, it may be because the voltage between the jump start clamps is lower than 3V. You can try the BOOST mode. IMPORTANT: In the BOOST mode, V2200Air will automatically output for 30 seconds. It is never allowed to directly connect the positive jump start clamp to the negative one in this mode. Otherwise, there will be a strong current that may cause damage, injury or even death. The operation in the BOOST mode is similar to that in the Jump Start mode. You need to press the BOOST button 14