V450 Config Guide (EN)

Configuration Guide for V450 Version 2.1, August-2023 Table of Contents ........................................................................................................................ 1  Introduction Wired Configurations ............................................................................................................................ 2  USB  RS232  EtherNet/IP  PROFINET Wireless Configurations ........................................................................................................................

3  USB (Bus Powered)  USB (Separate Power)  RS232  Bluetooth  EtherNet/IP  PROFINET Introduction This guide was created to assist in selecting the correct part numbers for each possible configuration and have been divided into two sections, wired and wireless. For each configuration you will find the corresponding list of part numbers required. Please select the configuration that best suits your individual application. Omron Automation Americas 2895 Greenspoint Parkway, Suite 200, Hoffman Estates, IL 60169 2801 Rochelle Rd., Suite 100, DFW Airport, TX 75261 100 Consilium Place, Suite 802, Toronto, Ontario, M1H 3E3

Стр. 1

Wired Configurations USB RS232 EtherNet/IP PROFINET Omron Automation Americas 2

Стр. 2

Wireless Configurations USB (Bus Powered) USB (Separate Powered) Note: USB bus powered recharge times will be longer than that of USB separate power RS232 Bluetooth Omron Automation Americas 3

Стр. 3

V450 Handheld Barcode Reader Frequently Asked Questions Q. Do I need to order a battery with the wireless handheld unit? A. No, each wireless handheld unit (V450HDS36780001), includes a battery. Additional batteries (98- 9000224-01) can be ordered separately if you wish to have more than one. Q. Can I connect the wireless cradle through USB? If so, will the cradle recharge the handheld’s battery? A. Yes, the USB is available for both the wired and wireless units. The USB bus cable (12900094601) will provide power to the cradle and to recharge the battery.

However the battery will recharge much faster if the cradle is connected by the USB cable with separate power (12900094201) and power supply (98900018101). Q. When connecting the V450 using RS232, does the unit need the external power supply? A. Yes, the RS232 connection requires the RS232C cable (12900095301) with power to be supplied by the separate power supply (98900018101) into the cable. This is the same for both the wired and wireless configurations. Q. Is the wireless V450 Bluetooth? A. Yes, wireless handheld unit (V450HDS36780001), uses Bluetooth communication to connect from the handheld to the cradle.

The Cradle is then connected into the system with one of the possible configurations. However you may choose to connect the wireless handheld unit directly to a Bluetooth host device. A video showing the Bluetooth to host connection can be found at: https://automation.omron.com/en/us/video/player/21299 Q. Do I need the external battery charger? A. In most wireless configurations, the cradle (12900093701) provides charging for the battery. However if the handheld is directly connected to a host device over Bluetooth, then the external 4-slot battery charger (98900018501) with power supply (98900018201) & cable (12900095901) is a good option to re-charge the battery in the handheld.

Omron Automation Americas 5

Стр. 5