1 Setup of Camera & Software Vision 1-2 Setup of Camera & Software Vision (FJ-S ЈЈЈЈ Series) Additional Information The image input time for the second and subsequent GigE cameras in the flow is approximately 50ms longer than that of the first one. 1 Make the following settings as required depending on the system configuration. • Set the External I/F Port No. • Edit the FJ series setting file "FZ-Option.ini" and set the port number of the External I/F. The folder path depends on the installation method. (Example: "C:\Program Files\OMRON\FJ Soft- ware(x64)\Release_x64\FZ-Option.ini") "FZ-Option.ini" defines the setting of FJ movement. Main Identifications are below.
1-2-6 Setup of Software Precautions for Correct Use • If the connected camera is changed, reset the parameters used in Camera Image Input GigE. • If a scene data created with another camera and sensor controller is imported, there may be cases where the setting may be incompatible with the current camera. In that case, please go in to the Processing item Setting UI in the TDM Editor and change the setting to an appropri- ate value in that menu. • The FJ software, Camera Configuration Tool and IP Configuration Tool will not function prop- erly if they are all open and running at the same time. When using any of these, always check that none of the others are currently open and in use.
• There may be settings in the Camera & Software Vision package that cannot be used due to related settings in the Operating System Settings - Communication - Address Setting. When use Camera & Software Vision, It is necessary to connect with PC network at "Address setting". 1-15 FJ Series (Camera & Software Vision Package) PC Vision System Camera Setup Guide (Z428-E1) Others Section Identification Explanation Logging imageLoggingEnabled Image logging Enable/Disable • 0: Disable • 1: Enable SerialNormal enabled Serial communication Enable/Disable • 0: Disable • 1: Enable portName Set the port No. to use. When port No. is lower than 10(X): COMX When port No. is higher than 10(YY):
\\.\COMYY UdpNormal enabled UDP communication Enable/Disable • 0: Disable • 1: Enable TcpNormal enabled TCP communication Enable/Disable • 0: Disable • 1: Enable EtherNetIP enabled EtherNetIP communication Enable/Disable • 0: Disable • 1: Enable localMacAddress Describe MAC address in use by the format below. XX-XX-XX-XX-XX-XX