2 Mounting and Wiring the Vision HAWK Smart Camera System Components Mounting and Wiring the Vision HAWK Smart Camera Important: Pin 9 (Host RxD) must be tied to ground (Pin 7) when using a flying lead cable and the serial port is not being used. The camera may not boot to completion if RxD is not grounded. Isolate unused wires. The ends of unused wires must not touch each other. • Mount the camera ( 1 ) securely as required by the application. 1 Mounting holes • Connect the Ethernet cable ( 2 ) from “B” on the camera ( 1 ) to the network. • Connect the power supply cable ( 3 ) to “3” on the QX-1 ( 4 ). • Connect the trigger ( 5 ) to “T” on the QX-1 ( 4 ).
• Connect the “Common” cable ( 6 ) from “A” on the camera ( 1 ) to “2” on the QX-1 ( 4 ). • Plug in the power supply ( 3 ). 1 1 For most C-Mount lenses: • Loosen all lens screws to allow free lens movement. • Install first set screw in the available slot. • Remove one lens screw and install second set screw to allow for adjustment. Important: Configuration details may vary by lens model. 6 2 6 2 4 4 3 5 3 5 Standard Vision HAWK Vision HAWK C-Mount Vision HAWK Smart Camera Guide 2-9