Chapter 3 Optics and Lighting Wiring for Strobe Illumination (NPN) In Strobe mode, the external illuminator is strobed with the exposure of the camera to maximize light for the short exposure times needed in dynamic applications. Warning: Contact between Pin 5 (gray wire) and any ground or voltage source less than or equal to 3.5VDC may cause erratic operation in this configuration. Contact between Pin 5 (gray wire) and any voltage source greater than 3.5VDC will damage the illuminator.
* Insulate Pin 5 (gray wire) 3-8 Vision HAWK Smart Camera Guide S mart Series Illuminator Vision HAWK Connector Connector A Smart Series Illuminator to to to to to Vision HAWK (Connector A) Pin Signal Name Pin Signal Name 1 +24VDC 2 Power 2 Trigger – 6 Output 3 3 DC Ground 7 and 12 Ground and Output Common 4 Trigger + 2 Power 5 Dim No Connection* N/A