• Do not attempt to dismantle, repair, or modify the product. • Should you notice any abnormalities, immediately stop use, turn OFF the power supply, and contact your OMRON representative. • While the power is ON or immediately after the power is turned OFF, the Sensor Controller and camera case are still hot. Do not touch the case. • When disposing of the product, treat it as an industrial waste. • Do not drop the product nor apply excessive vibration or shock to the product. Doing so may cause malfunction or burning. • This product is heavy. Be careful not to drop it while handling. • A lithium battery is incorporated, so a severe injury may rarely occur due to ignition or explosion.
• Be sure to take fail-safe measures externally when controlling stages and robots by using the measurement results of the Sensor Controller (axis movement output by calibration and alignment measurement). Installation Environment (FH-SMDA-GS050B) • Do not use the product in the environment with flammable or explosive gases. • To secure safety for operation and maintenance, install the product apart from high-voltage devices and power devices. • Avoid installing the product in places with vibration as much as possible. Power Supply and Wiring (FH-SMDA-GS050B) • Make sure to use the product with the power supply voltage specified.
If a DC voltage exceeding the rating or an AC voltage is applied, the circuit parts may be burnt or exploded. • Do not connect the power supply with polarity reversed. • Use a DC power supply with safety measures against high-voltage spikes (safety extra low-voltage circuits on the secondary side). • Use an independent power source for this product. Do not use a shared power source. • Never apply more than the rated voltage or AC power supply to this product. It may cause malfunction. • The recommended power supplies are as follows: - When not attaching the lighting module, use S8VK-G06024 (OMRON) or S8VS-06024 (OMRON).
cable or duct is used, the product may receive induction and it may cause malfunctioning or breakage. • Wire high-voltage cables or power cables are separated from the cables of this product. If the same • Do not short-circuit the load on the open collector output. • Apply load not exceeding the rating. • Before wiring an I/O cable, attach a crimping terminal. Do not connect cables just twisted together to the power supply or terminal block directly. • Insulate unnecessary signal cables so that they do not contact any other signal cables.
• After wiring the cables, confirm if the power supply is appropriate, if there is miswiring such as short- circuit of load, if the load current is appropriate, and if FG is connected appropriately. Otherwise, the product may be broken due to miswiring etc. • Take enough safety measures such as a failsafe circuit before using the product. 15