Warning 9 WARNING This product must be used according to this manual and Instruction Sheet. Failure to observe this may result in the impairment of functions and performance of the product. This product is not designed or rated for ensuring the safety of persons. Do not use it for such purposes. Never connect the AC power supply with this product. When the AC power supply is connected, it causes the electric shock and a fire. A lithium battery is built into the Controller and may occasionally combust, explode, or burn if not treated properly.
Dispose of the Controller as industrial waste, and never disassemble, apply pressure that would deform, heat to 100°C or higher, or incinerate the Controller. If you keep watching the LED light, it may have an adverse effect on the eyes, do not stare directly into the light emitted from the LED. If a specular object is used, take care not to allow reflected light to enter your eyes. Do not touch the terminals while the power supply is ON. Doing so may result in electrical shock. Please take external safety measures so that the system as a whole should be on the safe side even if a failure of a Sensor Controller, a failure of a 3D Vision Sensor, or an error due to an external factor occurred.
An abnormal operation may result in serious accident. Please take fail-safe measures on your side in preparation for an abnormal signal due to signal conductor disconnection and/or momentary power interruption. An abnormal operation may result in a serious accident. FH series must be handled by those who have the expertise in electricity. Read the reference manuals carefully to understand the contents well, and make the proper use of this product accordingly. Keep this document safely for ready reference at any time. Note that this document does not include detailed information on the use of this product, including safety precautions.
Please obtain manuals and instructions of the devices and equipment that constitute the system, and thoroughly read precautions such as "Safety Precautions", "Precautions for Safe Use", and "Precautions for Correct Use" before using the system. According to Article 36, 31 and 32 of the Occupational Health and Safety Regulations, work to teach, inspect, repair and adjust industrial robots falls under "dangerous or harmful work" as defined in the Occupational Health and Safety Act. Under Article 59 of the Occupational Safety and Health Act, operators are obliged to provide workers with "special training for safety or health".