2 How to Modify the dm.config File to Change Camera and System Assignments System Components What To Do When Visionscape Is Not Working Within Normal Operational Parameters Sometimes when you install or upgrade Visionscape (or install something after Visionscape) things start to work incorrectly. This can be caused by registration problems. All of the components used for Visionscape are in the C:\Vscape\610_10\Dll directory. To ensure that they are all registered you should first make sure that no Visionscape applications are running (including the AVP Backplane). Then do the following: 1. Open a command prompt window (type CMD in the Run… box). 2. Navigate to the directory shown above.
You can do this by whatever means you prefer, but a step-by-step way would be to type: a. cd .. b. cd .. c. cd Vscape d. cd 610_10 e. cd dll 3. Type aregsvr * 4. This will register all the Visionscape components again. Another problem that some customers have encountered seems to be related to the installation process, although this affects the dm.config file. The error seen in the Visionscape debug window looks like this: CAvpBackplane:: CreateAll From Config file cannot access config file Exception thrown One possible fix for this is: 1. Open the command prompt and navigate to the same folder as above. 2. Type the following:
regasm visionscape.configuration.dll /tlb Again, be sure that all Visionscape components are shut down before doing this. For additional assistance, contact Microscan’s help desk at: helpdesk@microscan.com . Visionscape GigE Camera Guide 2-61