VLT ® 2900 Series Shifting from Local operation to Remote operation in parameter 002 Local/remote operation , while this pa- rameter has been set to Remote operation : The local reference will be replaced by the remote-operated ref- erence signal. Not active (DISABLE) [0] Active (ENABLE) [1] In this parameter you can select/deselect the reversing function on the LCP control panel. The key can only be used if parameter 002 Local/remote operation is set to Local operation [1] and parameter 013 Localcon- trol to Local control, open loop [1] or Local control as parameter 100 [3].
Not active (DISABLE) [0] Active (ENABLE) [1] In this parameter, the local [STOP]-key can be engag- ed or disengaged on the control panel and on the LCP control panel. If Disable [0] is selected in this parameter, the [FWD/ REV] key will be disabled. See also parameter 200 Output frequency range . If Not active [0] is selected in this parameter, the [STOP]-key will be inactive. NB! If Not active [0] is selected, the motor can- not be stopped by means of the [STOP]- key. Not active (DISABLE) [0] Active (ENABLE) [1] In this parameter, the reset function on the control panel can be engaged/disengaged.
Not active (DISABLE) [0] If Not active [0] is selected in this parameter, the reset function will be inactive. Active (ENABLE) [1] In this parameter, the jog function on the LCP control panel can be engaged/disengaged. NB! Select Not active [0], only if an external reset signal has been connected via the digital inputs. If Not active [0] is selected in this parameter, the [JOG]- key will be inactive. = factory setting, () = display text, [] = value for use in communication via serial communication port 16 MG.29.A3.02 - VLT ® is a registered Danfoss trademark 016 Local reversing (LOCAL REVERSING) Value: 014 Local stop (LOCAL STOP) Value: Function: Function: Description of choice:
Description of choice: 017 Local reset of trip (LOCAL RESET) Value: Function: 015 Local jog (LOCAL JOGGING) Value: Description of choice: Function: Description of choice: