VLT ® 2900 Series Technical data, mains supply 3 x 380 - 480 V According to international standards Type 2905 2907 2911 2915 2922 2930 Output current I INV. [A] 1.7 2.1 3.0 3.7 5.2 7.0 (3 x 380-415V) I MAX (60s) [A] 2.7 3.3 4.8 5.9 8.3 11.2 Output power (400 V) S INV. [KVA] 1.1 1.7 2.0 2.6 3.6 4.8 Typical shaft output P M,N [kW] 0.55 0.75 1.1 1.5 2.2 3.0 Typical shaft output P M,N [HP] 0.75 1.0 1.5 2.0 3.0 4.0 Max. cable cross section, motor [mm 2 /AWG] 1) 4/10 4/10 4/10 4/10 4/10 4/10 Input current I L,N [A] 1.6 1.9 2.6 3.2 4.7 6.1 (3 x 380-480 V) I L,MAX (60s)[A] 2.6 3.0 4.2 5.1 7.5 9.8 Max. cable cross section, power [mm 2 /AWG] 1) 4/10 4/10 4/10 4/10 4/10 4/10 Max.
pre-fuses IEC/UL [A] 20/20 20/20 20/20 20/20 20/20 20/20 Efficiency 2) [%] 96 96 96 96 96 96 Power loss at 100% load [W] 28 38 55 75 110 150 Weight [kg] 2.1 2.1 2.1 2.1 3.7 3.7 Enclosure 3) type IP 20 IP 20 IP 20 IP 20 IP 20 IP 20 According to international standards Type 2940 2955 2975 2980 2981 2982 Output current I INV. [A] 9.1 12 16 24 32.0 37.5 (3 x 380-480V) I MAX (60s) [A] 14.5 19.2 25.6 38.4 51.2 60.0 Output power (400 V) S INV. [KVA] 6.3 8.3 11.1 16.6 22.2 26.0 Typical shaft output P M,N [kW] 4.0 5.5 7.5 11.0 15.0 18.5 Typical shaft output P M,N [HP] 5.0 7.5 10.0 15.0 20.0 25.0 Max.
cable cross sec- tion, motor [mm 2 /AWG] 1) 4/10 4/10 4/10 16/6 16/6 16/6 Input current I L,N [A] 8.1 10.6 14.9 24.0 32.0 37.5 (3 x 380-480 V) I L,MAX (60s)[A] 13.0 17.0 23.8 38.4 51.2 60 Max. cable cross sec- tion, power [mm 2 /AWG] 1) 4/10 4/10 4/10 16/6 16/6 16/6 Max. pre-fuses IEC/UL [A] 20/20 25/25 25/25 50/50 50/50 50/50 Efficiency 2) [%] 96 96 96 97 97 97 Power loss at 100% load [W] 200 275 372 412 562 693 Weight [kg] 3.7 6.0 6.0 18.5 18.5 18.5 Enclosure 3 type IP20 IP20 IP20 IP20/ NEMA 1 IP20/ NEMA 1 IP20/ NEMA 1 1. American Wire Gauge. Max. cable cross section is the largest cable cross section that can be attached to the terminals. Always observe national and local reg- ulations.
2. Measured using a 25 m screened/armoured motor cable with a rated load and rated frequency. 3. IP20 is standard for VLT 2905-2975, whereas NEMA 1 is an option. All about VLT 2900 MG.29.A3.02 - VLT ® is a registered Danfoss trademark 83