10-122 A/C system 10. A/C and Safety System 10.1.10.13 Removal and refitting of battery cooling module A/C inlet pipe assembly (EV) Removal procedure 1. Turn off all electrical appliances and the start switch. 2. Disconnect the battery negative terminal (refer t o 3.1.6.1 Maintenance and inspection of battery ) 3. Recover the refrigerant (refer to 10.1.12.12 Recovering/adding refrigerant) 4. Removing the engine compartment left and right front trim panel assemblies (refer to 8.6.6.20 Removal and refitting of engine compartment left front trim panel （ EV ） 5.
Remove the left and right rear trim panel assemblies of the engine compartment (refer to 8.6.6.12 Removal and refitting of engine compartment rear trim panel assembly ) 6. Remove the battery cooling module A/C inlet pipe assembly. a. Unscrew 2 fixing bolts of the battery cooling module A/C inlet pipe assembly. b. Remove the battery cooling module A/C inlet pipe assembly ① . Tightening torque of bolt: 10±1Nm. CAUTION: – Sealing pipeline connectors. Refitting procedure The refitting procedure is performed in reverse order. CAUTION: – Replace the O-ring with a new one, and apply A/C compressor lubricating oil to the O-ring.
– Vacuum the A/C system after the refitting is completed (refer to 10.1.12.14 A/C system vacuuming – Add the refrigerant (refer to 10.1.12.12 Recovering/adding refrigerant) VOYAH FREE