that the driver is in a state of fatigue, it will issue an alarm and display the corresponding informa- tion on the instrument cluster screen → Fig. 11 to warn the driver to pay attention. The instrument cluster displays the corresponding information for about 5 seconds, and may display it again if necessary. The system stores the last displayed information. WARNING Do not take advantage of the extra conven- ience provided by the driver fatigue warning system to risk driving - beware of causing acci- dents! Regular breaks should be taken during long journeys, and the rest periods should be long enough.
Press the button on the multifunction steer- ing wheel to switch off the information displayed on the instrument cluster → page 23. The infor- mation can be redisplayed through multifunction display → page 19. ● Drivers should always ensure that they are physically fit to drive. ● Never drive a vehicle under fatigue. ● The system is not always able to detect driv- er fatigue in all circumstances. Please read the instructions in the “System Limitations” section of this manual carefully. Working condition Only when the vehicle speed is 65 km/h to 200 km/h can the system evaluate the fatigue degree of the driver through the running state of the ve- hicle.
● In rare cases, the system may misinterpret appropriate driving actions as indicating that the driver is fatigued. ● The system does not issue emergency alerts for “drowsy” drivers! System limitations The driver fatigue warning system has certain system limitations. Therefore, the system may not be able to correctly identify the driver's driv- ing condition when the following driving condi- tions occur: ● Be sure to observe the relevant information displayed on the instrument cluster and op- erate the vehicle as required. The driver fatigue warning system only ap- plies to driving on highways and good hard surfaces.
– When vehicle speed is below 65 km/h, – When driving along a road with many curves – Speed higher than 200 km/h, If the system is faulty, you should check the system at the qualified workshop as soon as possible. – While driving on a construction site – When driving on bad roads – In bad weather – When driving a vehicle in a sports style – When the driver is distracted Time The fatigue warning system will be reset if: Please refer to at the start of the chapter on page 13.
– Switch off ignition switch – The driver unbuckled the seat belt and opened the driver's side door Models equipped with analogue instrument cluster – Press the button on the instrument clus- ter until the display displays the text Time → page 14. – The vehicle stays in place for more than 15 mi- nutes When the vehicle travels at a low speed for a long time (below 65 km/h), the driver fatigue warning system automatically reset. If the speed is increased, the system will reassess the driver's driving condition when the speed is higher than the above speed. – Release the button . The display displays the current time and enters the hour setting mode.
– Press the button 0.0 SET repeatedly until the desired number of hours is displayed. Hold down the button 0.0 SET to quickly adjust the hour value. – After setting the hour value, press the button to enter the minute setting mode. Owner's manual 20