have built-in seat belt guides and side pad- ding. Therefore, the company recommends the use of child seats with backrest. Two sets of child seats are suitable for children up to 7 years old, and three sets are suitable for chil- dren 7 years old or older. Regulatory requirement Standards and regulations for the use of child seats and their fixtures may vary from region to region. If the standards and regulations stipulate that it is not allowed to install a child seat or car- ry a child on the front passenger seat, please comply with the relevant requirements. The rele- vant regulations, standards and laws are superior to those described in this manual in principle.
Not all children fit the weight classification above. Likewise, not all seats are suitable to be installed in the car. Therefore, it is important to verify that the child seat is suitable for children to sit safely and can be reliably installed in the car. Information about installing a child seat When installing child seats, pay attention to the following tips. The following tips apply to child seats with any fixture. Child seats by approval categories Children seats can be divided into general pur- pose, semi-general purpose and vehicle special types according to the license category.
– Carefully read and pay attention to the child seat instructions provided by the child seat manufacturer → . – General purpose : Universal child seats can be installed in all vehicles. No specific model needs to be listed. Universal child seats with ISOFIX need to be fixed by the Top Tether. – Whenever possible, the child seat should be installed in the rear seat behind the front pas- senger seat so that the child alights on the side near the curb. – Semi-universal : In addition to meeting the standard requirements of the general license, the semi-general License requires a safety de- vice for securing the child seat, which is sub- ject to additional testing.
The semi-universal child seat comes with a list of applicable mod- els. Only the train type listed in the list can use the child seat. – If the rear-facing child seat is to be used in the front passenger seat, the front passenger front airbag must be turned off. – When using a child seat in a front passenger seat, the front passenger seat must be moved back as far as possible. And put the seat back- rest in an upright position → page 28. – Model specific : The vehicle-specific license re- quires the in-car dynamic testing of child seats for each applicable vehicle type. Special model child seat also has a suitable model list.
– If it is necessary to install a child seat in the rear seat, leave enough space for the child seat. Push the front passenger seat forward in- to position if necessary. Make sure the driver or front passenger is sitting properly in the seat → page 28. Basic information on installing and using a child seat – Adjust the tilt of the seat backrest so that the child seat fits perfectly. If the seat head re- straints is touched when installing the child seat and the child seat cannot fit with the seat backrest, push up or remove the seat head re- straints behind the child seat completely and store it safely in the car → page 28. Please refer to and at the start of the chapter on page 43.
Airbag sticker The car may have stickers with important infor- mation about the front passenger airbag. Its con- tent depends on the country and may vary. The sticker may be affixed in the following locations: – On the visor above the driver and/or front pas- senger → Fig. 35 . Pay attention to the warning message before in- stalling the child seat → . Fig. 35 The airbag tag on the sun visor Owner's manual 44