Installation How to Use 5. Start Cleaning Turn On/Off Pausing Adding Water or Cleaning Mop Pad During Cleaning Once the power indicator of the vacuum-mop changes from pulsing white to solid white, it is fully charged. Press the buton , or you can use the Mi Home/Xiaomi Home app to start cleaning. Press and hold the buton to turn on the vacuum-mop. Once the power indicator turns solid white, the vacuum-mop is in standby mode. To turn off the vacuum-mop, press and hold the buton while the vacuum-mop is stationary. Turning off the vacuum-mop will end the current cleaning task. Press any buton to pause the vacuum-mop during cleaning. To resume cleaning, press the buton .
Press the buton to end the current cleaning task and the vacuum-mop will go back to the charging dock. If you need to add more water to the vacuum-mop or clean the mop pad during a cleaning task, press any buton to pause the vacuum-mop, then remove the mopping module. Afer adding water or cleaning the mop pad, reatach the mopping module, then press the buton to resume the cleaning task. Note: The mop pad should be cleaned afer every 30 minutes of use to ensure adequate water flow and cleaning effectiveness. Note: The vacuum-mop cannot be turned off while charging. Note: When the vacuum-mop is paused, placing it onto the charging dock will end the current cleaning task.
If you need to continue cleaning, try to start the vacuum-mop in the same position where it was paused. 6. Remove the Mopping Module Cleaning Press the buton to start cleaning. Press any buton to pause during cleaning. Fault Status Afer the vacuum-mop finishes cleaning and returns to the charging dock, press the side clips of the mopping module inward and pull to remove the module. Cleaning Methods If the vacuum-mop encounters an error during operation, the power indicator will blink orange and you will hear a voice alert. To check for a solution, please refer to "Troubleshooting". Note:
When the vacuum-mop is charging or not in use, remove the mopping module, pour out all remaining water in the tank, and clean the mop pad to prevent mildew or lingering odors. Note: The vacuum-mop cannot start cleaning if the batery level is low. Please recharge it before cleaning. If the vacuum-mop starts running low on batery during a cleaning task, it will automatically return to the charging dock to recharge. Once the vacuum-mop is fully recharged, it will resume cleaning where it lef off.
Please tidy up any cables on the floor before cleaning (including the charging dock power cable) to prevent the vacuum-mop from geting caught on them, which could accidentally shut off electrical appliances or cause damage to objects or cables. By default, if the vacuum-mop completes a cleaning task in less than 10 minutes, it will clean the area a second time. Upon activation, the vacuum-mop will methodically clean each room in an S-shape patern, then finish by cleaning along edges and walls to ensure a thorough job. When the vacuum-mop is done cleaning, it will automatically return to the charging dock to recharge. Note:
The vacuum-mop will automatically enter sleep mode afer encountering an error if no action is taken within 10 minutes. If the vacuum-mop has an error, placing it onto the charging dock will end the current cleaning task. Sleep Mode Charging When the vacuum-mop is in standby mode or paused, press and hold the buton for 3 seconds to start Spot Clean mode. In this mode, it will clean a square-shaped area of 1.5 Ч1.5 meters directly around the vacuum-mop. When the spot cleaning is done, the vacuum-mop will automatically return to its original location and shut off.
1.5m The vacuum-mop will automatically enter sleep mode afer 10 minutes of inactivity, then the power and charging indicators will go off. To wake up the vacuum-mop, press any buton. Auto mode: The vacuum-mop will automatically return to the charging dock to recharge afer it finishes cleaning. Manual mode: When the vacuum-mop is paused, press the buton to send it back to the charging dock. The indicator of the buton is pulsing when the vacuum-mop is charging. 1.5m Note: The vacuum-mop will not enter sleep mode until it is fully charged. Pulsing orange: Batery level is less than 15%. Pulsing white: Batery level is more than 15%. Note:
The vacuum-mop will automatically return to its original cleaning position if it cannot locate the charging dock. If this happens, please manually place the vacuum-mop onto the charging dock. Note: Activating Spot Clean mode will end the current cleaning task of the vacuum-mop. 9 10