How to Install Installing the Accessories onto the Vacuum Cleaner Installing the 2-in-1 Charging & Storage Mount 1. The 2-in-1 charging & storage mount should be installed in a cool, dry place with an electrical outlet nearby. Prior to installing, ensure that there are not any wires or pipes in the space directly behind where the mount will be installed. 2. The bottom of the mounting template sticker should be level and at least 1.03 m from the ground, and its top should have at least 30 cm of clearance above it. 3. Use a power drill with an 8 mm drill bit to drill a hole into each hole marker on the mounting template sticker, then insert a wall plug into each hole. 4.
Align the mounting holes on the 2-in-1 charging & storage mount to the holes on the wall, then attach the mount to the wall using the included screws. Insert until it clicks into place Insert until it clicks into place Extended Dock You can simultaneously charge the replaceable battery* when charging the vacuum cleaner on the 2-in-1 charging & storage mount. 30 cm Extended Dock Charging Plate 1.03 m Note: Mini electric brush should not be used with the extension rod. Mounting Template Sticker Screw Wall Plug 6 7 * The replaceable battery is not included and purchased separately. Recommended Height: At least 1.03 meters from the ground