How to Use Before Use • Check if the heater is in good condition, and make sure the power cord is not damaged or broken. Note: If the room temperature is higher than the expected temperature in the constant temperature mode, the heater may switch to the natural mode. • Use a 220–240 V AC electrical outlet with a rated current of at least 10 A. It is recommended to plug the power cord into a wall socket, and do not share the same power strip with other appliances. • Press the power button on the back of the heater before use. When the heater makes a notification sound, it is connected to power. Scheduled Standby • Press the scheduled on/off button to cycle through the scheduled standby times:
one hour, two hours, four hours, eight hours, and off. • This heater is an electric appliance for close use. When using the heater to blow air directly, it is recommended to place it one to two meters away from you for optimal heating performance. • If no operation is performed within three seconds after the scheduled standby time is selected, the indicator will display the expected temperature. If no expected temperature is set, the indicator will go out. On/Standby • Press the on/standby button to turn on the heater. • After the scheduled standby time is selected, the indicator will show the remaining time once you press the scheduled on/off button.
You can press the button again within three seconds to cycle through the scheduled standby times. • Press the on/standby button when the heater is on, the heater will dissipate heat for 30 seconds, then enter standby mode. Note: After the heater has been running in the natural mode for 30 seconds, pressing the on/ standby button can make the heater directly enter standby mode. Enabling/Disabling Oscillation • Press the oscillation button to enable or disable the oscillation mode. • Press the on/standby button when the heater is dissipating heat, the heater will return to the previously used settings. Enabling/Disabling the Child Lock Note:
When planning not to use the heater for a long time, make sure the heater is in standby mode and then turn off the heater and unplug the power cord. • To enable or disable the child lock function, press and hold the oscillation button and the mode button simultaneously for seven seconds. • The child lock function can also be disabled by turning on the heater again after disconnecting it from power or unplugging the power cord. Switching the Mode • Press the mode button to cycle through the modes of constant temperature, hot, warm, and natural.
Enabling/Disabling the Wi-Fi Adjusting the Expected Temperature • To enable or disable Wi-Fi, press and hold the scheduled on/off button and the oscillation button simultaneously for seven seconds. • Press the temperature button to cycle through the expected temperatures of 22°C, 24°C, 26°C, and 28°C. Resetting the Wi-Fi • After the expected temperature is set, the heater will automatically enter the constant temperature mode. Other modes do not support the settings of the expected temperature. • Press and hold the scheduled on/off button and the temperature button simultaneously for seven seconds. When the heater enters the network configuration mode, the Wi-Fi is reset successfully. 5