Care & Maintenance 5. Rinse the pre-filter, cyclone assembly, and dust compartment with water until they are clean, then set each component aside to thoroughly dry for at least 24 hours. Wipe the contact points of the vacuum cleaner with a soft dry cloth if they are dirty. Installing the Dust Compartment, Pre-filter, and Cyclone Assembly 3. Slightly tilt the dust compartment so its slot aligns with the clip on the vacuum cleaner. Then gently push the dust compartment until it clicks into place. 1. Insert the cyclone assembly vertically into the dust compartment, and make sure that the handle of the cyclone assembly line up with the slot on the left side of the dust compartment.
Turn the handle clockwise until it locks, then flip the handle down. 2. Place the pre-filter with its front side facing up into the cyclone assembly. 1 2 1 Pre-filter 2 Insert until it clicks into place Pre-filter Cyclone Assembly Dust Compartment Notes: Notes: Do not use detergents, polishes, or air fresheners to clean the dust compartment. Do not clean the dust compartment, pre-filter, or cyclone assembly in a dishwasher or washing machine, nor attempt to dry any component in a tumble dryer, oven, microwave, or near an open fire. The dust compartment should be rinsed out at least once a month. The pre-filter and cyclone assembly should be cleaned once every 3 to 4 months. 16 17