Turning On/Off & Vacuuming Press and hold the on/off buton for 1 second, then the vacuum cleaner starts working and it runs on the standard mode by default. You can switch the mode as needed. Hold the handle of the vacuum cleaner by pushing it back and forth to vacuum and clean the floor with the floor brush. You can also use the long nozzle or flat nozzle according to your needs. Press the on/off buton again to stop the vacuum cleaner. On/Off Buton 9 When the Vacuum Cleaner is Working When the batery level is low, the batery level indicator will blink red, please recharge the vacuum cleaner soon. If the vacuum cleaner runs on the standard mode, it cannot be switched to the turbo mode.
If it is not recharged in time, the batery voltage will get too low, then the vacuum cleaner will automatically turn off to protect the batery. If the vacuum cleaner turns off due to running out of the batery, please recharge it in a timely manner. Otherwise, the batery may damage because of its over-discharging if it is not used for an extended period of time. Notes There is a small amount of batery in the vacuum cleaner when you get it. It is recommended to connect the power adapter to fully charge the vacuum cleaner before its first use. When charging, the vacuum cleaner cannot be used. Storing Accessories The accessories can be stored on the wall mount when not in use.
Vertically insert the long nozzle or flat nozzle into the wall mount until you hear a click, with the release buton as the direction shown in the figure. To remove the accessories from the wall mount, press the release buton and simultaneously pull them down vertically. Wall Mount Release Buton 10