T3100 Manual

T3100 Manual

InstructionsT3000 Series Probe Assembly Drawing1T3100 100MHz 100:1 Passive Probe0 10Hz F 0M 5p /10 pF 10234T316100M 0V 00 X:2 MADC5Part Exposition : 1. Probe Rod 2. Probe Tip 3. Ground Lead 4.Tip Locating Sleeve 5. Adjustment ToolNote:Contents of this document are subject to change without notice.SpecificationsThese characteristics apply to a T3000 series probe installed on a specified oscilloscope.When used with another instrument, the oscilloscope must have an input impedance of 1 M . The instrument must have a warm-up period of at least 20 minutes and be in an environment that does not exceed the limits.MaintenanceLow-Frequency probe CompensationBefore taking any measurements using a probe,first check the compensation of the probe and adjust it to match the channel inputs.Most oscilloscopes have a square wave reference signal available at a terminal on the front panel used to compensatethe probe.Connect the probe to the signal source to display a1KHz test signal on your oscilloscope.ItemAttenuation Input Resistance Input Capacitance Compensation Range System Bandwidth Maximum Working Input Voltage Net Weight Cable Length Temperature Operating Non operating HumidityT31001:100100MΩX100: 3.5pF~10.5pFLAdjust trimmer L until seeing flat-top square wave on the display.10pF~35pFMaximum Working Voltage Derating CurveDC~100MHz2500V(VDC+Peak AC)X100: 2000VDC+Peak AC 65g 120cm2000V100X1500V-10 ℃--+50℃ -20 ℃--+75℃1000V≤ 85%(Relative Humidity )01MHz10MHz100MH