Downloaded from https://www.everyspec.com ADS-43A-HDBK 2.2.5.2 Bearings Magnetic Particle Inspection for Rings and Steel Cages. Fluorescent Penetrant Inspection for Non-Ferrous and Non-Magnetic Materials. Nital Etch Inspection for Rings and Elements. Balance of Cage, when called out on drawing. Bore Diameter for Main Shaft Bearings. 2.2.5.3 Shafts Magnetic Particle Inspection or Fluorescent Penetrant Inspection. Ultrasonic Inspection, if required. Nital Etch Inspection. Balancing, when called out on drawing. Bearing and Centering Journal(s) Runout, Diameter, and Concentricity. 2.2.5.4 Splines Magnetic Particle Inspection or Fluorescent Penetrant Inspection. Nital Etch Inspection.
2.2.5.5 Threaded Components Magnetic Particle or Fluorescent Penetrant Inspection. Nital Etch Inspection, if called out on drawing. Flatness or Squared, if called out on drawing 2.2.5.6 Disks Master Comparator Chart for Dovetail or Fir Tree Slots. Contour Limits must be met on all surfaces on both sides of Dovetail or Fir Tree Slot simultaneously. Centering Journal(s) Runout, Diameter, and Concentricity. Magnetic Particle or Fluorescent Penetrant Inspection. 2.2.5.7 Compressor and Turbine Blades Master Comparator Charts for Blade Airfoils.
Master Comparator Charts for Blade Dovetails or Fir Trees Contour Limits must be met on all surfaces on both sides of Dovetail or Fir Tree simultaneously (Measurement over Pins). Magnetic Particle or Fluorescent Penetrant Inspection. Air and/or Water Flow Checks, if called out on drawing. 2 0