AH500 Quick Start The configuration is as follows. Rack 1 (eight-slot main backplane) Rack 2 (eight-slot extension backplane) Note: Owing to the consideration to the data transmission speed, the motion control modules and the network modules (exclusive of the serial communication modules) have to be installed with the CPU module on the same backplane. Otherwise, the system can not operate properly. The common framework of the AH500 system (for system integration): The AH500 system can meet most system control requirements in the application field of the system integration. Generally speaking, the system framework is related to the positions of the equipments.
A control panel is usually placed among the equipments which are concentrated to save the wiring cost. However, there is usually more than one concentration point, and the distance between the concentration points is over 100 meters. If it is necessary for users to place more than two control panels, the RTU modules are required. The remote framework of the AH500 system not only fills the remote requirement, but also is combined with the extension of the local I/O. Under most conditions, a control panel instead of a backplane can be regarded as a remote I/O station. In addition, the backplanes, the power supply modules, and other modules are compatible with one another.
The convenience of planning the system is increased, and the difficulty of choosing the products is also decreased. Eight racks at most 1-4 Power supply CPU module Network module Motion control module Motion control module Motion control module Motion control module Motion control module Motion control module Power supply Digital input module Digital input module Digital output module Analog input module Temperature measurement module Serial communication module