Opening a new project Opening a new project Device type settings Device type settings Creating a program Creating a program Move the cursor to this position. The rung is inverted as shown right. Move the cursor to this position. The rung is inverted as shown right. 5-19. Edit of Rungs …Copy & Paste Refer to the former sections to enter a rung. Ctrl C (Copy a rung) ‹ You can copy instructions selected by dragging a mouse. ‹ You can also cut selected rungs (instructions) by [Ctrl]+[X]. ↓ Press the ↓ key to move the cursor to this position. Press the ↓ key to move the cursor to this position. Ctrl V (Paste a copied rung) Click each instruction and then change the bit numbers.
Click each instruction and then change the bit numbers. ‹ When making a mistake, press or [Ctrl+Z] for Undo (return to the previous operation) press or [Ctrl+Y] for Redo (go to the next operation) 5-20. Entry of END Instruction At the creation of a new project, a section of the END instruction only is automatically generated. You do not need to enter an END instruction. At the creation of a new project, a section of the END instruction only is automatically generated. You do not need to enter an END instruction. IInnssttaallllaattiioonn ttoo SSttaarrttuupp Note: The END se created with ction is not generated when you load a program CX-Programmer V2 or the former versions.