00-44 POWER TAKE OFF Disassembly Steps 1. Inner Rod Assembly Press the stopper adapter side by a wrench and insert a Phillips screwdriver (large) in the groove of the control cable connector. Then ro- tate it counterclockwise, loosen it, and remove it. Notice: Be sure to press the stopper adapter side and loosen it on the control cable connector side. (Press the stopper adapter side not to rotate the spool valve. Besides, the three-rotation dump truck is in contrast with this.) NPA0098E Legend 1. PTO 2. Oil pump 3. Spring Pin Punch the spring pin in the idle gear shaft. (After having removed the idle gear shaft, punch the spring pin from the shaft.) Spring pin bar:
9-8529-2201-0 NPA0097E Legend 1. Oil pump 2. PTO 3. Inner rod assembly 2. Bolt Remove three bolts and separate the oil pump and PTO striking the oil pump by a plastic ham- mer (or wooden hammer). NPA0099E Legend 1. Spring pin 4. Idle Gear Shaft 5. Idle Gear 6. Needle Bearing Strike and remove the idle gear shaft and re- move the idle gear, then remove the needle bearing.