OM2200 Warnings And Cautions - Section 22 Page 22-3 A warning plate is mounted on top of the radiator surge tank cover near the radiator cap. The engine cooling system is pres- surized. Always turn the key switch OFF and allow the engine to cool before removing radiator cap. pressure is first released, removing the radiator cap after the engine has been running for a time will result in the hot coolant being expelled from the radiator. Serious scalding and burn- ing may result. Warning plates are mounted on the frame in front of, and to the rear, of both front tires. All personnel are warned that the clear- ances change when the truck is steered and could cause serious injury.
Warning plates are attached to both the hydraulic tank and fuel tank to alert technicians not to work on the truck with the body in the raised posi- tion unless body-up retention device (pins or cable) is in position. These danger plates are mounted on the outside of each frame rail to alert technicians to read the warning labels attached to the side of each of the accumulators (see below) prior to releasing internal nitrogen pressure or dis- connecting any hydraulic lines or hardware. There are similar decals mounted on top of each of the accumulators (both steering and brake) with the same danger message.
These warning decals are mounted on the side of each of the accumulators (both steering and brake) to alert techni- cians to discharge all gas and hydraulic pressure, and to read the maintenance/service manual prior to performing any service. e - s el tank to ank to d posi-