2-48 CAB AND FRAME Installation To install, follow the removal steps in the reverse order, noting the following points: 1. Tighten the mounting screw to the specified torque. Tighten: Rear door lock mechanism mounting screws to 6 N m (61.1 kg cm/52 lb in) 2. After installation, check the operation. Rear Door Outside Door Release Handle N2A0085E Legend 1. Rear door trim panel 3. Outside door release handle 2. Water-proof sheet Removal 1. Remove the rear door trim panel. Refer to “Rear door trim panel” in this section. 2. Remove the water-proof sheet. Refer to “Rear door lock mechanism” in this section. 3.
Disconnect the link and remove the 2 mounting bolts and remove the Outside door release handle.