MAINTENANCE TRANSMISSION LUBRICATION TRANSMISSION FLUID CHANGE/TORQUE STOP ADJUSTMENT The transmission lubricant level should be checked and changed in accordance with the maintenance schedule. Be sure vehicle is level before proceeding. Check vent hose to be sure it is routed properly and unobstructed. Follow instructions on following pages to check / change transmission lubricant. 1. Remove skid plate (if necessary). 2. Place a drain pan beneath the transmission oil drain plug area. 3. Loosen jam nut (A). 4. Turn adjuster bolt (B) in to allow the removal of drain plug. 5. Remove the drain plug and wipe the magneticend clean to remove accumulated metallic filings. 6.
After the oil has drained completely, install a new sealing washer and install the drain plug. Torque to 14 ft. lbs. (19.3 Nm). 7. Turn adjuster bolt (B) out until it touches the frame, and then an additional 1/2 turn. TRANSMISSION SPECIFICATIONS Specified Lubricant: Polaris Premium Synthetic Gearcase Lubricant ( PN 2871477 ) (Gallon) ( PN 2871478 ) (12 oz.) Capacity: 11.3 oz. (335 ml) Drain Plug / Fill Plug Torque: PVT Cover Drain Plug 14 ft. lbs. (19.4 Nm) B Transmission Dipstick A Forward 8. Tighten the jam nut securely while holding the adjuster bolt. 9. Add the proper lubricant through the dipstick hole until the oil level is between the upper and lower limits. Do not overfill. 10.
Check for leaks. 11. Reinstall skid plate if removed in Step 1. To check the level: 1. Remove dipstick and wipe clean. 2. Reinstall dipstick completely, remove and check the level. Add the proper lubricant as required to bring level into operating range as shown. Full Operating Range 2.8