STARTING THE ENGINE (CONT’D) Figure OI-55 Keyless Start 1 WARNING AVOID INJURY OR DEATH Fasten seat belt, start and operate only from the operator seat. Never wear loose clothing when working near machine. 2 W-2135-1188 3 4 Perform the PRE-STARTING PROCEDURE. (See PRE- STARTING PROCEDURE on Page 20.) P16616 Figure OI-54 Press ENTER CODE Button (Item 1) [Figure OI-55] . The display will light up and there will be two short beeps, CodE will appear on the LCD. Use the keypad (Item 2) [Figure OI-55] to enter the password. For each digit that you enter, a dash will appear on the LCD.
(You have 40 seconds to enter the password or the process will abort and you will need to start over.) If the password was entered correctly, there will be one long beep. 1 NOTE: If the password was incorrect there will be three short beeps and “Error” will appear on the LCD. Press the ENTER CODE Button again and start over. After three failed attempts, you must wait three minutes to try again. P16615 Press the START Button (Item 3) [Figure OI-55] and hold it until the engine starts. Move the engine speed control (Item 1) [Figure OI-54] to low idle. IMPORTANT Do not engage the starter for more than 15 seconds at a time. Longer use can damage the starter by overheating.
Allow starter to cool down for one minute before using starter again. I-2034-0700 Press the STOP button (Item 4) [Figure OI-55] to stop the engine. Stop the engine if the warning lights and alarm do not go OFF. Check for the cause before starting the engine again. Password Lockout Feature See Password Lockout Feature. (See Password Lockout Feature on Page 95.) 325/328 Excavator 23 Operation and Maintenance Manual