ASSEMBLY 17) If the vacuume pressure was dropped, seal did not fit properly. Then reassembling and seal inspection are required. 18) Fill specified lubrication oil in the pin after no air leakage is confirmed. Fill oil up to 2-3 kg/cm2 (196-294 kPa) 19) After completion of filling with oil, install the small plug with pushing tool (R5) to specified depth (L13). # Be sure oil comes out from hole when installing plug. Refill oil if oil does not come out. Coat outside of circumference of the small plug with lubricated oil before. 3. Master Link assembly (pin side) 1) Set and press fit master link. - 25 -