Operation 3.3 Operation Adjusting bucket positioner 1. Lower the bucket to the ground, set to the desired digging angle, return the bucket control lever at HOLD, then set the safety lever to the LOCK position and stop the engine. 2. Loosen 2 bolts (1), adjust the position of mounting bracket (4) of the proximity switch so that the rear tip of bar (2) is in line with the center of the sensing surface of proximity switch (3), then tighten bolts to hold the bracket in position. 3.
Loosen the two lock nuts of proximity switch (3), adjust so that the clearance between bar (2) and the sensing surface of proximity switch (3) is within a range of 3 to 5 mm (0.12 to 0.20 in), then tighten the locknuts to hold in position. Tightening torque: 14.7 to 19.6 N·m (1.5 to 2.0 kgf·m, 10.8 to 14.5 lbft) 4. After adjusting, start the engine and raise the lift arm. Oper- ate the bucket control lever to the DUMP position, then oper- ate it to the TILT BACK position and check that the lever is automatically returned to the HOLD position when the bucket reaches the desired digging angle.
Bucket level indicator (A) and (B) at the top rear of the bucket are the level indicators, so the bucket angle can be checked during operations. (A): Parallel with cutting edge A (B): 90 degrees to cutting edge B GK032219 WA150-5H – VEAM934100 3-93 3 2 1 4 GK015007