OM7006 03/10 Radio / CD Player - Section 70 Page 70-3 SEEK SENSITIVITY: To adjust seek sensitivity, press the AUDIO knob until SEEK and the sensitivity level appear. Rotate the AUDIO knob to the desired setting. Increasing the sensitivity will help find more stations, including slightly weaker ones, while decreasing it will cause fewer, but stronger stations to be found. USING THE ALARM Momentarily pressing the ALARM (10) button will dis- play the alarm set time. When the ALARM icon is on the display, the alarm has been set. If the radio is on when the alarm sounds, there will be a beeping noise. If the receiver is off, the alarm will turn on and play the radio at the alarm volume.
The alarm will continue to sound until the snooze is activated or the alarm is turned off. SPEAKERS: Press the AUDIO knob until SPKR 4 appears on the display; rotate the knob to switch to 2-speaker functionality. SPKR 2 will appear on the display. Setting the Alarm After 5 seconds of inactivity, the receiver will return to the default display. 1. Press and hold the ALARM (10) button for 2 seconds until the ALARM icon and the display show AL TIME plus the current alarm time. This indicates the alarm-setting mode. USING THE CLOCK 2. Press and release the +TUNE/SEEK- (6) until the desired alarm hour appears on the display. The clock can function in a 12 or 24-hour mode.
The 12-hour mode distinguishes between AM and PM. The 24-hour mode operates as military time. To tog- gle between the two modes: 3. Press the ALARM (10) button again to select the minutes display. 4. Press the +TUNE/SEEK- (6) until the desired alarm minutes appear on the display. 1. Turn the key switch ON. 2. Press and hold the TMSET/ DSPL button for 2 seconds until the digits flash. This indicates you are in the time set mode. After 5 seconds of inactivity, the receiver will return to the default display, and the ALARM icon will remain illuminated indicating the alarm is set. 3. Press and release push-button 5 to toggle between 12-hour and 24-hour modes.
Turning the Alarm Off After 5 seconds of inactivity, the display will return to the default display, and the current mode will be set. Press and hold the ALARM (10) button until the dis- play shows ALARM DISABLED and the ALARM icon on the display disappears. Setting the Clock Activating Snooze 1. Turn the key switch ON. 2. Press and hold the TMSET/DSPL button until the hours digits flash. Press any button on the radio faceplate when the alarm is sounding. The alarm will sound again in 9 minutes. 3. Press the +TUNE/SEEK- (6) to set the correct hour. Setting Alarm Volume 4. Press the TMSET/DSPL button again, and the minutes digits will flash. 1. Turn the receiver on. 5.
Press the +TUNE/SEEK- (6) button to set the correct minute. Seconds are reset to zero when the minutes setting is changed. 2. Press and hold the ALARM button for 2 sec- onds until the ALARM icon and the display shows AL TIME plus the current alarm time. Rotate the AUDIO knob to increase or decrease the alarm volume as desired. After 5 seconds of inactivity, the display will return to the default display and the clock will be set.