POWER STEERING 3B1-23 Reassembly 1. Valve housing and worm shaft assembly 2. O-ring 3. O-ring 4. Seal Ring When the O-ring and seal ring are installed, use in- staller for alignment. N3A0150E Legend 1. Stub shaft 2. Valve housing 3. Piston 2. Ball, Tube, Tube Grip, Screw and Washer Be careful not to lose the ball when remove the ball tube. Number of Balls: 28 3. Seal Ring N3A0175E 5. Piston Assembly 6. Ball, Tube, Tube Grip, Screw and Washer 1) Put the valve housing assembly (1) horizontal- ly. Insert the ball (2) into the ball tube hole in the piston (3) while rotating the stub shaft (4). Thus, the ball can be easily mounted. N3A0151E 4. O-ring 5. O-ring Using needle, scriber or equivalent.
6. Valve housing and worm shaft assembly. N3A0176E 2) Apply a sufficient amount of grease to the inner surface of the tube (1). Put and paste the balls (2) to the inner surface of the tube. Then, put the other ball tube onto the tube to which grease has been applied and the balls have been pasted. Inspection and Repair Refer to “Power Steering Unit” in this section.