• Switch on the ignition • Close the bleed screw. • Release the brake and switch off the ignition. • Disconnect the brake bleeding device from the bleed screw. • Disconnect the container from the wheel-circuit reservoir. L Note: After switching on the ignition, always wait for the BMW Integral ABS to complete its self-diagnosis. Do not operate the brake lever until self-diagnosis has completed. MAX MIN e Attention: below the “min” level. • pump just starts up. • • L Note: rapidly. • just disappears from view. 00.45 e Attention: After changing and/or bleeding the brakes, always top up the fluid in the wheel-circuit reservoir to the correct level in accordance with the instructions.
R28340090 be visible in the contain- he base of the wheel-cir- be covered by the fluid. peated if the fluid drops otbrake lever until the while topping up the con- uid if necessary. d with virtually no pres- vary the brake pressure. ure the faster the fluid is m, which means that the servoir drops all the more lear and free of bubbles, the fluid in the container w.