Output sensor 1 Remove the following assemblies: Toner cartridge, media tray, and cable pod. See “Toner cartridge” on page 15 through “Cable pod” on page 17. Left side and back covers. See “Left side cover” on page 18 through “Back cover” on page 19. 2 Disconnect the output sensor (callout 1) wire harness (at the ECU end). Unlace the harness from the harness lance points. 3 Remove the single output sensor mounting screw and remove the sensor. 1 Figure 11. Remove the output sensor 22 Chapter 2 - Removal and replacement Q1342-90910