6 Disconnect the delivery motor connector (callout 5). 7 Open six cable guides and remove the cables. Hint The six cable guides are located on the following: one from the shutter solenoid, two from the feeder cover detection switch, one from the weight solenoid, and two from the motor. 8 Remove one screw, and the cable clamp on the shielded cable (callout 6). Note When reinstalling the lower registration roller assembly, one end of the cable clamp goes into the sheet metal. 9 Remove the tie wrap from the motor mount (callout 7), but keep the cables captured in the tie wrap. 10 Remove one screw (callout 8). 172 Chapter 6 Removal and replacement C8523-90921 165.
11 Push the cable cover to your right to disengage four claws (callo 12 Tilt the cable cover up and remove it. 7 9 48 15 26 Lower registration roller assembly (2 of 10)