Installing the finishing device The MFP is delivered with a finishing device. The finishing device comes in its own box, and must be set up and installed with the MFP. The following are finishing devices: 3,000-sheet stacker 3,000-sheet stapler/stacker Multifunction finisher Note Make sure that the printer and finishing device are installed on a level surface so that they function correctly. 1 Position the printer in its permanent location, allowing room to install the finishing device. 2 Lock the front wheels on the printer. 3 Open the box that contains the finishing device and remove the packing material. The box includes two bins:
a face-up bin (callout 1), and a stacker bin or a stapler bin (callout 2). Note The multifunction finisher is delivered with the bins installed. 2 1 2 Figure 16. Installing the finishing device (1 of 2) 4 Place the finishing device in upright position. 5 Remove all of the orange packing materials and tape from the finishing device and the cables. 6 Position the finishing device on the left side of the printer. 7 Lower the connecting rod to a horizontal position. 8 Place the end of the connecting rod into the U-shaped metal slot on tray 4 and align the connecting rod with the gray alignment label. 9 Slide the blue plastic bracket into the metal slot until it locks into place.
10 Connect the Jet-Link cable to the printer by attaching it to the connector labeled “Finishing Device”. Note Make sure that the Jet-Link cable is connected securely to the printer. The finishing device will not operate unless the Jet-Link cable is connected. 11 Install the power cord(s). 12 Connect the power cord on the finishing device to the upper connection on tray 4. 13 Connect the printer power cord to the printer. C8523-90921 Setup 35 2