Chapter 4 Control Registers 4-5 CR# Address Attribute Register name Explanation factory settings #43 H102B X R/W Way in which weights measured by CH1 are filtered out K0: Not filtering weights (factory setting) K1: Filtering out the maximum weight measured K2: Averaging weights #44 H102C X R/W Way in which weights measured by CH2 are filtered out #45 H102D X R/W Filter parameter for CH1 Filtering out the maximum weight measured: K0~K8 Averaging weights: The number of weights which need to be averaged should be in the range of K1 to K100.
#46 H102E X R/W Filter parameter for CH1 #48 H1030 O R/W Upper limit for determining whether the digital value corresponding to a weight measured by CH1 is 0 grams If the digital value corresponding to a weight measured by CH1/CH2 is in the range specified, bit 5/bit 10 in CR#51 will be set (the weight measured is will be counted as 0 grams). Default value: K10 Setting range: K0~K32767 #49 H1031 O R/W Upper limit for determining whether the digital value corresponding to a weight measured by CH2 is 0 grams #51 H1033 X R/W Status code The status of the load cell module used is stored in this register. Please refer to the status table below for more information. Factory setting:
H’0000 #52 H1034 O R/W RS-232 station address The default value in CR#52/CR#54 is K1. The setting values in CR#52 and CR#54 should be in the range of K1 to K255. The default value in CR#53/CR#55 is H’0000 (ASCII, 9600 bps, 7 data bits, even parity bit, one stop bit). Please refer to the communication format table below for more information. #53 H1035 O R/W RS-232 communication format #54 H1036 O R/W RS-485 station address #55 H1037 O R/W RS-485 communication format #95 H105F O R/W Zero point tracking range of CH1 Setting range: 0 ~ 30000; when set the setting to 0, it indicates zero point tracking is disabled. #96 H1060 O R/W Zero point tracking time of CH1 Setting range: 5 ~ 1000; unit:
0.1 s #97 H1061 O R/W Zero point tracking range of Setting range: 0 ~ 30000; when set the setting to 0,