DeviceNet Network Scanner DVPDNET-SL 4 Configuration of DVPDNET-SL 4.1 Configuration through DeviceNet Builder Software Before DVPDNET-SL starts to work normally, it must be configured through DeviceNet Builder software. 4.1.1 Selection of Communication Channel Max 8 DVPDNET-SL modules can be connected to the left side of PLC and every DVPDNET-SL is a communication channel. When there are three DVPDNET-SL modules connected to PLC’s left side and DeviceNet Builder software is on line, the following dialog box will pop up for selecting the current channel. DVP-PLC Operation Manual 8 Parameter Explanation Unit No. The unit No. of the first DVPDNET-SL（DNET Scanner）on the left side of PLC is 1.
PLC’s left side can be connected with max 8 DVPDNET SL. The further _ DVPDNET-S is from PLC MPU, the larger its unit No is. Name DVPDNET-SL’s name in DeviceNet Builder software. Code For displaying the current mode of DVPDNET-SL: master mode or slave mode. Input mapping The register areas which PLC MPU distributes to DVPDNET-SL.The areas are mainly used to receive the message from DeviceNet Slave and the data from slave in the bus will be automatically updated to these registers. Output mapping The register areas which PLC MPU distributes to DVPDNET-SL.
The areas are mainly used to control DeviceNet slave and the control data in these registers will be automatically sent to DeviceNet slave in the bus. Slave will take some action accordingly after receiving the data.