DeviceNet Network Scanner DVPDNET-SL 8 Setup of Slave Mode DVPDNET-SL can serve as slave through modifying of the mode by software. As DVPDNET-SL serves as slave, the default input / output data length is 8 bytes and max input / output data length is 255 bytes. DVPDNET-SL can be set as slave mode in the following method. 1) Connect the devices according to below figure. PC accesses PLC MPU via RS232 or RS485. DVP28SV DVPDNET-SL DeviceNet Builder 2) Open DeviceNet Builder software, and select “Setup” => “Communication Setting” => “System Channel”, and the “Serial Port Setting” dialog box will appear as below. 3) Set up the communication parameters in the PC and DVP-SV, e.g.
the communication port, address, baud rate and communication format. Click on “OK” after configuration is finished. DVP-PLC Operation Manual 24 Item Function Default COM Port COM port on the PC to be used to communicate with DVP-SV COM1 Address Communication address of DVP-SV 01 Baud rate Communication speed between the PC and DVP-SV 9,600 (bps) Data Bits Parity Stop Bit Communication protocol between the PC and DVP-SV 7 Even Parity 1 Mode Communication mode between the PC and DVP-SV ASCII