Kendrion Kuhnke Automation GmbH Hardware 4.2.3 CAN connector The CAN bus connects to the front of the module by means of a 4-pole Molex Micro-Fit Connector 3.0 TM . Connector (supplier: Farnell) 43025-0400: female Micro FIT 3.0 43030-0010: crimp socket PK100 MOLEX-79516-1043-MICRO-PASS 4WAY CABLE ASSEMBLY 3M You may use a CAN to USB adapter to connect the CAN bus to the programming PC. (Source: http://www.canusb.com/ You may also need to adapt the D-SUB connectors to Micro-Fit. Figure 9: CAN to USB adapter (Lawicel) Kuhnke FIO CAM Control ( E 808 GB ) 18 11/10/2017 CAN GND _ L CAN CAN _ _ GND H Figure 8:
4-pole male to female CAN connector GND CAN _ L CAN _ GND CAN _ H Pin Function 1 2 CAN L _ 3 CAN GND _ 4 5 6 7 CAN H _ 8 9 Housing Earth (GND) Information Please note that both ends of CAN cables require a 120Ω termination between CAN L and _ CAN H. _