Leaving a gap of approximately 100 mm from the ceiling to the top of the wall plate makes it easier to install and remove the projector. When Installing Multiple Projectors When installing two or more projectors in parallel, see "Internal Specifications" p. 5 for details on the operating temperature. If the environment is too hot, the projector may overheat and the power may turn off without warning. 100mm When installing two or more projectors in parallel, leave a gap of at least 1,200 mm between the projectors. Installation Environment If you cannot secure a gap of approx. 1,200 mm, install a partition to block the heat vented from the projector's air exhaust vent.
The partitions should be larger than the exhaust vent (approx. 20 mm in all directions), and installed approximately 400 mm from the exhaust vent and 200 mm from the intake vents. When powerful light of over 800 lux shines on the projection surface or around the projection surface (10 cm to the left or right, 10 cm from the bottom, or 3 cm from the top), the interactive function may not operate correctly. Close curtains to shut out direct sunlight, and turn off fluorescent lights. Or install the projector in a location that is not subject to direct sunlight or fluorescent lights.
Projection Surface For ultra-short focus projectors, if the projection surface is uneven, the image may appear warped. We recommend using screens that can easily be kept smooth such as a magnetic screen or a board screen. 400mm 200mm When projecting a screen with multiple projectors, use the Edge Blending function to create a seamless image. When projecting a screen with an aspect ratio of 3:1, set the Blend Range for Edge Blending to 600. 18 1200mm 600