■ Projector Parts - Interface 10 No. Name Note A Audio Out port (Stereo mini pin jack) Outputs audio from the current input source to an external speaker. B Remote port (Stereo mini pin jack) Connects the remote control to the projector using the optional remote control cable set and inputs signals from the remote control. When the remote control is connected, the remote receiver on the projector is disabled. C Cable holder Pass a commercially available cable tie through here to secure cables. D RS-232C port (Mini D-Sub 9-pin, male) Use to connect an RS-232C cable to control the projector from a computer.
E Service port (USB connector Type B) This port is used for batch settings and firmware update. F USB-A port (USB connector Type A) This port is used for batch settings and firmware update. This projector can be powered at 5 V/2 A. G LAN port (RJ-45) Use a 100Base-TX or 10Base-T network cable. To ensure proper data transmission, use a Category 5 shielded cable or better. H HDBaseT port (RJ-45) You can use a network cable up to 100 m in length. To ensure proper data transmission, use a Category 5e STP cable or better. However, operation is not guaranteed for all input/ output devices and environments. This port is compatible with HDCP2.3.
I SDI In port (BNC) Inputs video signals from SDI compatible video equipment. SDI Out port (BNC) Outputs video signals input from the SDI In port to an external monitor. J HDMI2 port (HDMI) Inputs video signals from HDMI compatible video equipment and computers. This port is compatible with HDCP2.3. (Audio is only supported by PCM) K HDMI1 In port (HDMI) Inputs video signals from HDMI compatible video equipment and computers. This port is compatible with HDCP2.3. (Audio is only supported by PCM) L HDMI1 Out port (HDMI) Outputs signals to an external monitor or another projector. This port is compatible with HDCP2.3.