BITS monitor command Set external output signals 9-16 (8 bits) to the binary representation of the current monitor speed setting. If the monitor speed were currently set to 50% (110010 binary), then signals 9-16 would be set as shown after the command: BITS 9,8 = SPEED(1) 9 →0 (off) 13 →1 (on) 10 →1 (on) 14 →1 (on) 11 →0 (off) 15 →0 (off) 12 →0 (off) 16 →0 (off) Set external output signals 1-8 (8 bits) to the binary representation of the constant 255, which is 11111111. Thus, signals 1-8 will all be turned on.
BITS 1,8 = 255 Related Keywords BITS program instruction BITS real-valued function IO monitor command RESET monitor command SIG real-valued function SIG.INS real-valued function SIGNAL monitor command SIGNAL program instruction eV+Operating System Reference Guide, 2.x,18321-000 Rev A Page 41