DEFAULT monitor command DEFAULT monitor command Syntax DEFAULT DISK = physical_device>unit:directory_path Function Define the default relationship between the eV+ disk logical device and the physical device to be accessed. Also, display the current default. Usage Considerations The (simpler) CD command can be used instead of the DEFAULT command. Parameters physical_device Optional name of the physical device to be associated with the disk logical device. Acceptable device names are "DISK", and "TFTP", which must be specified without quotes, and can be abbreviated to "DI", and "TF").
The ">" character must be omitted if the physical device is omitted, in which case, the previous default physical device is not changed. When the physical device is specified, the default unit is canceled if no unit is specified. unit Optional string specifying the desired default unit. l For the DISK physical device (i.e., a controller-based disk), this parameter is the letter name of the disk drive of interest (specified without quotes). l For the TFTP device, this is the name or IP address (in dotted decimal format) of the TFTP server that will be accessed. The ":" character must not be entered if the unit is not specified.
In that case, the previous default unit is not changed (except as noted above). directory_path Optional string specifying the directory path of interest. Normally, this parameter will contain file names and backslash (\) characters. (For disk devices, eV+adds a "\" if one is not included at the end of a path specification.) eV+Operating System Reference Guide, 2.x,18321-000 Rev A Page 56