23 (Operation of TMflow) Select [RecvString] to open the Network Settings dialog. Make sure that [Choose Device] is set to FH. Click [Edit Device] to open the Device Settings screen. Set the IP address and port number of the Vision Sensor. Click [Done] to save the settings. 4 (Operation of TMflow) Select [SendString] to open the Network Settings dialog. Make sure that [Choose Device] is set to FH. After confirming, close the [fhsetup] node configuration dialog. 5 (Operation of TMflow) Like shown on the right figure, Click the icon to save the [FHSETUPMAIN] project to save your network settings. 6