Parameter setting mode In the parameter setting mode, inverter functions (parameters) are set. The following table explains the indications in the parameter setting mode. 4.1.3 Digital characters and their corresponding printed equivalents Digital characters displayed on the operation panel are as follows. 68 4. BASIC OPERATION 4.1 Operation panel Operation panel indication Function name Description Refer to page Parameter setting mode Under this mode, the set value of the displayed parameter number is read or changed. 69 Parameter clear Clears and resets parameter settings to the initial values. Calibration parameters and offline auto tuning parameters are not cleared.
203 All parameter clear Clears and resets parameter settings to the initial values. Calibration parameters and the offline auto tuning parameters are also cleared. 203 Fault history clear Deletes the fault history. 208 Initial value change list Identifies the parameters that have been changed from their initial settings. 204 Group parameter setting Displays parameter numbers by function groups. 79 0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z