Before you can use voice commands to control functions of your Garmin Boat Switch digital switching system, you must configure your Garmin Boat Switch device to assign identifying information to the switches you want to control using voice control ( Configuring Digital Switches for Voice Control , page 157 ). GRID Remote Control Pairing the GRID Device with the Chartplotter from the Chartplotter NOTE: These steps are applicable to both the GRID device and the GRID 20 device. Before you can pair the GRID 20 device with the chartplotter to make the data connection, you must supply power using batteries, the included power cable, or a NMEA 2000 ® network connection.
Before you can pair the GRID device with the chartplotter, you must connect it to the Garmin ® Marine Network. 1 Select > System > Station Information > Input Device Pairing > GRID™ Pairing > Add . 2 Select an action: On the GRID remote input device, press SELECT . On the GRID 20 remote input device, press and until the remote control beeps three times. Pairing the GRID Device with the Chartplotter from the GRID Device NOTE: This is not applicable to the GRID 20 device. 1 On the GRID remote input device, press + and HOME at the same time. A selection page opens on all of the chartplotters on the Garmin ® Marine Network.
2 Rotate the wheel on the GRID remote input device to highlight Select on the chartplotter you want to control with the GRID remote input device. 3 Press SELECT . Pairing the GRID 20 Device with the Chartplotter from the GRID 20 Device 1 On the GRID 20 device connected to the same NMEA 2000 ® network as the chartplotter, hold and until the device beeps. A GRID™ Pairing page opens on all of the chartplotters on the network. 2 Press or repeatedly on the GRID20 device until Add is highlighted on the chartplotter you want to control with the GRID 20 device. 3 Press the knob to confirm.
Rotating the GRID Remote Input Device For certain installation situations, you can rotate the orientation of the GRID device. NOTE: This is not applicable to the GRID 20 device. 1 Select > Communications > Marine Network . 2 Select the GRID device. 3 Select GRID Direction and select the installation orientation.
32 GPSMAP® 8400/8600/8700 Series Owner's Manual Controlling the Chartplotter Voice Command Function Raise Brightness of Light 2 Steps up the brightness for the digital switch assigned to the second light Make Lamp 2 Not So Bright Reduces the brightness of the digital switch assigned to the second light Sound Horn 1 Triggers the digital switch assigned to the first horn Stop Primary Horn Turns off the digital switch assigned to the first horn Sound Primary Horn for 2 Seconds Triggers the digital switch assigned to the first horn for two seconds Turn on Baitwell 1 Turns on the digital switch assigned to the first baitwell or live well pump Stop Live Well 2 Turns off the digital switch assigned to the second baitwell or live well pump Continuously Run the Sixth Bait Tank Turns on and runs the digital switch assigned to the sixth baitwell or live well pump in a manner where it will not turn off automatically Turn on the Navigation Lights Turns on the digital switch assigned to the navigation lights Switch Navigation Lights Off Turns off the digital switch assigned to the navigation lights Turn on Steaming Lights Turns on the digital switch assigned to the steaming lights Switch the Steaming Lights Off Turns off the digital switch assigned to the steaming lights