Installation Procedure KX11 PHEV 2023 2-30 Engine control system (DHE15-ESZ) Engine 1 Install the intake pressure and temperature sensor (water-cooled intercooler subassembly) and tighten the fixing bolts 1 of the intake pressure and temperature sensor (water-cooled intercooler subassembly). Torque: 10N·m Caution 1. Before installing the sensor, dip a grease stick into an appropriate amount of engine oil and apply it evenly to the chamfer of the sensor mounting hole. 2. Before assembly, check sealing rings for damage or missing. If any, replace them. 3. Storage, transportation and assembly processes must be protected against static electricity and touching the sensor pins is prohibited. 4.
Do not plug or unplug any sensor with electricity during the energizing operation such as cold or hot test. 2 Connect the harness connector A of the intake pressure and temperature sensor (water-cooled intercooler subassembly). 3 Install the engine trim cover assembly. 4 Connect the negative cable of battery. 6 Use the GLDS diagnostic program. On the [Software] tab, select the corresponding module and follow the steps prompted by the diagnostic program to complete the software flash operation. 2.2.6.5 Replacement of Electric Motor Coolant Valve 5 Close the engine compartment cover. Removal Procedure