6 Configuring with the programming assistant USB noFILE No file found Neither a global nor single configuration file has been found. The configuration process has been aborted. The display re turns to standard view after a couple of seconds. USB GLObAL Global configuration file found A global configuration file has been found. Press “E” to con firm and start the configuration process. Press any other key to abort the process. If no keys are pressed within 10 seconds, the process is, again, automatically aborted. Single configuration file found A single configuration file has been found. Press “E” to confirm and start the configuration process. Press any other key to abort the process.
If no keys are pressed within 10 seconds, the process is, again, automatically aborted. USB SInGLE USB COnFIG Counter is being configured The counter is configured using the file it has found. USB no CFG No configuration command executed A configuration file has been found and the configuration started, but no command has been executed. Very probably, the file does not contain any configuration commands (com ments not excluded). USB donE Configuration complete The configuration was completed without error. In order to re configure the counter, remove the USB drive and insert again. USB E1 Error 1:
Drive was removed before configuration started A configuration file was found, but the interface could no lon ger detect a drive when the configuration process was started manually. The process is aborted and a restart prevented since no configuration has taken place. The display returns to stan dard view after a couple of seconds. 17