Table 2-10 Jetdirect menus (continued) Menu item Submenu item Submenu item Values and Description Ping Test This test is used to check network communications. This test sends link-level packets to a remote network host, then waits for an appropriate response. To run a ping test, set the following items: Dest Type Specify whether the target product is an IPv4 or IPv6 node. Dest IP IPV4 : Type the IPv4 address. Packet Size Specify the size of each packet, in bytes, to be sent to the remote host. The minimum is 64 (default) and the maximum is 2048. IPV6 : Type the IPv6 address. Timeout Specify the length of time, in seconds, to wait for a response from the remote host.
The default is 1 and the maximum is 100. Count Specify the number of ping test packets to send for this test. Select a value from 1 to 100. To configure the test to run continuously, select 0. Print Results If the ping test was not set for continuous operation, you can choose to print the test results. Select Yes to print results. If you select No (default), results are not printed. Execute Specify whether to initiate the ping test. Select Yes to initiate the test, or No to not run the test. ENWW Use the Administration menu 31